Litter Robot Cycling Light Stays On. How to resolve the issue depends on the flashing sequence: Test cats by pressing on the globe just above the entrance in a forward and downward motion.
LitterRobot 3 Troubleshooting Learn more on LitterRobot Blog from www.litter-robot.com
To abort the clean cycle, press reset or empty. Adjust your cat sensor by pressing the reset button. If it cycles and the light turns blue.
Turn The Night Light Function On And Off By Pressing And Holding The Power Button.
Be sure your device is running normally. To unpause the unit, press the cycle button. As the globe rotates clockwise, litter will fall through the waste port and into the waste drawer.
So If You Get The Lr4, I Would Try A Lighter Litter.
Thank you, it isn't in sleep mode, there is just one solid yellow light. Leonard september 14, 2018, 5:35pm #3. Unplug your power supply and then wait for 10 seconds.
Activate The Cat Sensor By Pressing On The Globe Just Above The Entrance In A Forward And Down Motion.
Eco friendly litter saving design, and suitable for multiple cats. But be confirmed at least after two to three cycles. To quit this mode, simply press and hold the cycle button until the yellow light turn off.
After Some Testing, It Seems Like Dr.
Press and hold cycle button for 5 seconds. How to resolve the issue depends on the flashing sequence: To abort the clean cycle, press reset or empty.
If Your Device Doesn’t Cycle Automatically, Press “Cycle.”.
The blue light should turn off and the red light should come on. After the litter is emptied, the globe pauses with the yellow light bar on and awaits your. If you want to reset the cat sensor, you have to press reset when the unit is at the home position.
Share
Post a Comment
for "Litter Robot Cycling Light Stays On"
Post a Comment for "Litter Robot Cycling Light Stays On"